On this page 7 sections
At a glance
Lever → dust → repeater → lamp. Activate one tick at a time to see the delay.
Tick 0
Select a component and click the cell. 'Click' toggles a lever and button. On the field: arrows — cursor, Enter or space — action, Delete — erase, R — rotate.
Select an example and turn on the lever.
| Component | Rule |
|---|---|
| Redstone Dust | Transmits a signal, losing one unit of power on each subsequent segment. |
| Lever | Switches with a second click; lever signal is 15. |
| Stone Button | After clicking, it emits a signal for 20 game ticks. |
| Support block | Wall torch support; can receive power from directed dust and devices. |
| Block of Redstone | A constant signal source with strength 15. |
| Wall Torch | When the support block is powered, it turns off with a two-tick delay. |
| Repeater | Boosts signal to 15 and holds it for 2, 4, 6, or 8 game ticks. |
| Redstone Lamp | Turns on with a signal; turning off is delayed by four game ticks. |
First, power flows from sources through connected dust. Then, power for support blocks and device entrances is calculated. Torch switches, repeaters, and lamp turn-offs are queued for future game ticks.
A repeater's arrow points to the output. Activating a repeater from the side blocks its state. A wall torch requires a support block behind it; levers or buttons can be attached to the support block.
One game tick at normal 20 TPS — 0.05 seconds. One redstone tick — two game ticks. The number on dust shows strength from 0 to 15, not time.
- "Signal Strength": Track the values along the line. Add a repeater before the point where the signal ends.
- 'Flame: OFF': Activate the lever on one side of a support block. After two game ticks, the torch on the other side will go out.
- "Delay of repeater": turn on the input and press "One tick." Compare delays of 2 and 8 game ticks.
- Block Repeter Lock: enable the side input, wait for its signal, then switch the main input. Remove the side power and test the subsequent toggle.
The scheme saves components, directions, delays, and lever positions. When opened, the calculation starts at tick zero; incomplete pulses and switch queues are not saved.
The calculation is intended for supported components in a single horizontal layer. Vertical connections, pistons, comparators, observers, quasi-connectivity, torch burning, and the order of complex simultaneous updates are outside the scope of this model.
For such devices, use the description redstone components and check your structure in your version of Minecraft. The Bedrock engine has its own rules and these are not applicable here.
Exporting .mcfunction places a Java schematic on stone floor from the execution position. Run it in a separate test world: the area of the field at two levels above the floor is cleared into components.
The link contains the schematic after the # character. The file and link are processed in your browser, without uploading a save to the site.
How to check a redstone schematic online?
Select an example or place components on the grid, turn on the lever, and click 'One Tick' or 'Start'. The number on the dust shows the current signal strength.
Can you save and reopen your schematic?
Yes. Download the JSON schema and open it using the load button. You can also copy the schema link: the data is stored within the fragment, without sending it to the server.
Does the simulator replace Minecraft's built-in validation?
He calculates supported flat chains and delays. Vertical transmission, pistons, comparators, torch burning, and complex update sequences are not simulated; such mechanisms are tested in-game.
A Java flat world: signal propagation and delayed switch queue. Limitations are listed on the page.