Immersive Engineering: First Energy., провода and мультиблоки

Immersive Engineering is built around wires, separate connection points, and multi-unit machines. First, prepare Engineer's Manual, Engineer's Hammer and Wire Cutters. The recipes are from your version: in a assembly, the author can change them.

The mode is available for certain issues of Forge and NeoForge. Choose a compatible file on the author ' s page, rather than moving it to the Fabric profile just because the number Minecraft has coincided. To work together, match mods and relationships with the server.

The main route is the source of rotation of ~ kinetic dynamo ~ low voltage line ~ energy storage device ~ consumer. First, obtain energy transmission along this short circuit; a large plant is not needed yet.

1. In the engineering manual, open the water wheel and the kinetic dynamo. Collect the specified connection: the wheel transmits the motion of the dynamite through its intended side.
2. Organize the flow of water around the wheel. Make sure the wheel actually turns; one block of water nearby does not prove the generator is working.
3. Prepare LV Capacitor and two compatible LV Wire Connector. One connector must receive energy from the source, and the other one must transmit it to the storage inlet.
4. Connect with LV Wire Coil: use it at the first point, then on the second. Do not mix the voltages of the wire and the connector.
5. Set the input side of the drive using the designations and manual for your version. Check to see if your energy supply is increasing.
6. Connect the drive output to one consumer. Check energy supply before serving ingredients.

The connection and relays play different roles. Relays help draw the line, but do not replace the energy exchange point with the machine. If there is a wire and the car is standing, start checking from this difference.

Open in the Engineer's Manual the page of the right machine and its volume diagram. Look at the layers, orientation and selected point of formation. First build a low-cost initial stage installation, such as a coke oven, and check the assembly principle.

1. Lay out all the required blocks and make sure that similar-looking materials are not mixed up.
2. Assemble the circuit layer by layer; leave spaces that are empty in the manual blank.
3. Use an engineer's hammer on the indicated block and on the correct side.
4. If the machine is formed, check the interface and inputs/outputs. Not every machine requires electricity: this is indicated on its page.

Other technological modes are compared in general selection. I don't know. If the goal is to start with IE, do not add another energy system until it has successfully tested its own source, reservoir, and consumer.

Author's Immersive Engineering page, sources and engineering guidance. Retrieved October 31, 2026.