Ender IO: machines, конденсаторы and Configuration conduits

Start with the recipes of an accessible generator, SAG Mill, and Alloy Smelter to JEI. The assemblies can change materials and intermediate alloys, so the list of ingredients from the old video is less reliable than the prescription for the installed output. For the first launch, a short line with two chests is sufficient: raw input and finished product.

Before automating, make one item manually. Put the right resource in the car, provide power and check the result. If the machine requires a capacitor, install it: Capacitor Missing means a required component, not a recommendation to speed up an already running machine.

Do not confuse the capacitor inside the machine with Capacitor Bank. I don't know. The first defines the parameters of the mechanism and the ability to operate, the second stores the power of the network. A full bank next to a car doesn't replace an internal component. Conversely, an expensive internal capacitor does not generate energy from the air.

Apply energy to a compatible power grid and open the interface of the machine. You need to see the growth of its internal reserve. If the bank's reserves are reduced and the car has zero, the problem is between them: connection, unset or output mode.

SAG Mill is broken by suitable raw materials; the side results depend on the recipe and the installed flow devices. Alloy Smelter is used for alloys and has processing modes. Do not promise to double any item: first check a specific prescription card and the expected number of results.

For starters, a stable small line is more useful than maximum improvements. Rapid machines boost the consumption and flow of items. Check after acceleration whether the generation can cover the load and if the exits are released. Otherwise, progress will be stopped by packs.

In a domain network, mode, channel and filter are important:

Modes are named relatively conduit networks. I don't know. Extract is taken from the chest at the front trunk; Insert is placed in a crusher. If you put Extract at both ends, the network doesn't get the right destination.

Gather the test transmission between the two normal chests. Set the first one on Extract, the second one on Insert, set up one channel color and allow work without an external redstone signal. Place one low-cost item. After successful transfer, replace the receiving chest with a machine and check its input side.

In one space there may be conduits of different types, but this does not combine their contents. The energy line will not transfer the object and the subject channel will not connect the ME network. The compatible types for AE2, Refined Storage or Mekanism chemicals depend on the installed modules and versions.

Use different channels for different tasks, e.g. one to deliver ore and the other to remove dust. The connections of one physical wire are involved in the appropriate logical routes. The matching pipes do not change the colour difference.

If the resource has multiple authorized recipients, set priorities. For distribution between the same machines, there is a Road Robin. This is a route distribution tool, not a promise of exactly the same number of items at any entry restriction: a full machine may still not accept another portion.

Do not turn on Self Feed without a task that needs to return to the same equipment. The "outset" ring can indefinitely run one material and prevent new shipments from being processed. Check each section's direction and leave a separate location for emergency manual shut-down.

In Alloy Smelter, only supply the ingredients of the right recipe. The total metal line can fill all slots with incompatible materials. Start with a white list and a small batch; only then connect production to the general warehouse.

For SAG Mill, pre-empt the place for by-products. A stopped car with a full exit is not broken. Send the main result and the by-matter to suitable storage facilities, but do not remove the overfill until you are sure what rare products it will destroy.

If production to order is required, move recipe management to autocraft AE2. Ender IO in this scheme delivers the ingredients and returns the finished item; the terminal should see the order completed.

Retrieved November 1, 2026: author's Ender IO page, repository and table of supported versions, interface signatures 1.21.1 and Item Conduit logic. Numerical speeds vary by file and configuration.